n plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings.

The length of the nipple is usually specified by the overall length with thread. It may have a hexagonal section in the center for a wrench to grasp (sometimes referred to as a "hex nipple"), or it may simply be made from a short piece of pipe (sometimes referred to as a "barrel nipple" or "pipe nipple"). A "close nipple" has no unthreaded area; when screwed tightly between two female fittings, very little of the nipple remains exposed. A close nipple can only be unscrewed by gripping one threaded end with a pipe wrench which will damage the threads and necessitate replacing the nipple, or by using a specialty tool known as a nipple wrench (or known as an internal pipe wrench) which grips the inside of the pipe, leaving the threads undamaged. When the ends are of two different sizes it is called a reducer or unequal nipple.

Threads used on nipples are BSP, BSPT, NPT, NPSM and Metric.

To match up the varying demands of the clients, we are engaged in offering extensive array of S.S. Bend Nose Cock. Our provided S.S. Bend Nose Cock is rigorously tested by quality controllers to ensure its reliable performance. Our prestigious clients can avail our entire products range from us at market leading prices. This product we offer is developed using quality grade materials, cutting-edge technology and advanced machinery under proper guidance.
 
Features:

Good design

Good quality

Safe in use

Pneumatic cylinder

available in following design

sc,dnc,mal,c2q,ms, etc

This crimped single and double acting cylinder has a stainless steel barrel and rod, anodized aluminum end-caps, NBR/PU seals and aluminum piston. The brackets may be rod end, feet, flange or trunnion fixing.

The stroke lengths for Series 16: 10 - 250 mm (minimum - maximum) for diameters 8 - 10; 10 - 300 mm for diameter 10. For Series 24 and 25: 10-600 mm for diameter 16; 10-1000 mm for diameters 20 - 25.

Bore sizes are 8, 10, 12 for Series 16 and 16, 20, 25 for Series 24 & 25.

The device operates at 0°C -80°C (with dry air -20°C) temperature, 1 - 10 bar (double-acting) pressure, 2 - 10 bar (single-acting). Filtered non-lubricated air is the medium. If lubrication is desired, ISO VG32 is ideal, and should be continuous.